1. The Snubnose starts from a solid block of steel

2. Shaping the sole at the toe and heel of the putter

3. Front view of the block with shaped heel and toe

4. Milling the face to 4 degrees

5. Finished Face milling

6. Milling the bumpers and cavity

7. Milling the cavity and shaping the bumpers

8. Milling and cleaning the cavity and shaping putter to weight

9. Front view with handstamping on the face

10. Rear view with nearly finished cavity and backside

11. Top view of the nearly finished Snubnose

12. And... the bottom view of the sole of a nearly finished Snubnose

13. Milling a nice clean radius on the bumpers

14. Handstamping the cavity

15. Milling a custom hosel

16. Welding the custom welding on the putter

17. Heating and bending the custom hosel to the desired offset and lie

18. Adding the nice non-glare satin finish to the putter

19. Final adjustments the putter to the customers desired specs